Bitaxe 3-Slot 10" Rack Mount — Snap-Lock Trays (Gamma/601) — Engineered PETG Design
Rack-mount three Bitaxe Gamma miners with tool-free snap-in trays.
Not a quick remix — an engineered design, iterated through six versions on a real mining rack:
- Snap-lock trays:** each Bitaxe rides its own tray (M3 heat-set inserts),
clicks into its bay, and releases by pressing two posts on the rear. Swap miners in seconds.
- Ears that don't snap:** chassis prints face-down so the rack ears are
continuous unbroken layers with 45° root fillets — the classic printed-rack- panel failure, engineered out. Snap fingers flex parallel to layers (no delamination).
- Verified fit:** tray hole pattern checked against the official Gamma 601
board files (49.5 × 92.7 mm) — not eyeballed.
- Test coupon included:** a 25-minute print validates the snap clearances on
YOUR printer before the long chassis print. No wasted spools.
- Full print guide: PETG settings, orientations, supports, assembly.
Fits standard 10" mini racks (RackMate class). Chassis 254 × 130 × 71 mm — needs a 250 mm+ bed (or split in your slicer). Hardware: 12× M3 inserts+screws.
Files: chassis, center tray, side tray (print 2, one mirrored), snap coupon, full guide. Personal-use license. I answer questions — snap tuning advice included.
